Phoenix MACX MCR-EX-1TS-I-OLP-temperature measurement transmitter 1145365,Ex I-output loop-powered temperature measurement transmitter can transmit RTD and TC sensor signals and signals from resistance sensors and voltage sensors through 4 mA ... 20 mA. HART, INSULARY ASSISTANT ISOLATION AMPLIFIER, STANDARD CONFIGURATION, SCREW CONNECTION

Product Type temperature measurement transmitter
product series MACX Analog
Channels 1
Model Intralternatively safe isolation amplifier
configuration Software
HART
insulation characteristics
Overvoltage Category II
pollution level 2

step response (0-99%) 1 s (TC)
1 s (RTD)
electrically isolated input/output
Test Voltage 2 kV AC (50 Hz, 60 s)
Power
Supply Voltage Range loop power supply, no external power supply required
11V DC ... 30V DC

signal
input signal temperature
measurement
Input Number 1
Input Voltage Range -20 mV ... 100 mV (minimum measuring range: 5 mV)
Available Sensor Types (RTDs) Pt, Ni, Cu sensors: 2, 3, 4 wires
Available Sensor Types (TC) A, B, C, D, E, J, K, L, N, R, S, T, U
Temperature measurement range -250°C ... 2500°C (range depends on sensor type)
Temperature measurement range ≥ 10 K (RTD)
≥ 50 K (TC)
Linear resistance measuring range 10 Ω ... 2000 Ω (minimum measuring range: 10 Ω)

signals: current
current output signal 4 mA ... 20 mA
20 mA ... 4 mA
Maximum current output signal 23 mA
load (UL- 11 V) / 0.023 A
HART coding FSK ± 0.5 mA
HART protocol version 7
transmission speed 1200 Baud
Power Filter 50/60Hz
communication resistance ≥ 250 Ω
impact suppression  7 s (HART)
7 s (measured value)

Connection Mode screw connection
stripping length 7mm
thread M3
Rigid conductor cross section 0.2 mm² ... 2.5 mm²
Flexible Wire Cross Section 0.2 mm² ... 2.5 mm²
Attachable Guide Cross Section AWG 24 ... 14
Tightening torque 0.5 Nm ... 0.6 Nm
2865340

Phoenix MACX MCR-EX-1TS-I-OLP-temperature measurement transmitter 1145365

Product Center

PRODUCT CENTER