Phoenix MINI MCR-2-NAM-2RO-PT-isolation amplifier 2902005, configurable NAMUR isolation amplifier, using in-line connection technology, suitable for proximity switches, floating switch contacts and switch contacts with resistor circuits. 2 transistor outputs. Configurable via DIP switch. In-line connection technology.
Product Type
isolation amplifier
Product Series
MINI Analog Pro
Channels
1
configuration
DIP switch
insulation characteristics: GB Standard
Overvoltage Category
II
pollution level
2
Function
configuration
DIP switch
electrical isolation
4 road isolation
galvanic isolation between input and output
is
rated conditions
450 mW
Electrical isolation input/output/power supply
Rated insulation voltage
300Vrms
Test Voltage
3 kV AC (50 Hz, 60 s)
insulation
reinforced insulation conforming to IEC/EN 61010-1
Power
Rated supply voltage
24V DC
Supply Voltage Range
9.6V DC ... 30V DC (DIN rail bus connector (ME 6,2 TBUS-2 1,5/5-ST-3,81 GN, order number 2869728) can be used to bridge the power supply. Can be stuck to a 35mm DIN rail conforming to the EN60715 standard))
Typical current consumption
18 mA (24V DC)
35 mA (12V DC)
power consumption
450 mW (9.6V DC)
signal: NAMUR
Input Number
1
valid input source
NAMUR proximity switch sensor (IEC/EN 60947-5-6)
Floating switch contact
Switch contacts with resistor circuit
switch threshold "0" signal current
< 1.2 mA (disabled)
switch threshold "1" signal, current
> 2.1 mA (ON)
Line Fault Detection
> 6 mA (short circuit)
< 0.35 mA (line break)
activated/deactivated via DIP switch
No-load voltage
8.2V DC ±10%
switching: transistor
Output Description
output 1: signal output; output 2: fault signal output or signal multiplier, can be set by DIP switch
Contact Type
2 N/O contacts
maximum switching voltage
30V DC
Maximum starting current
50 mA
minimum switching current
5 mA
Typical Response Time
10 µs
Typical closing time
35 µs
Switching frequency
5 kHz
2902040
넳넲
Phoenix MINI MCR-2-NAM-2RO-PT-Isolation Amplifier 2902005
