Phoenix MCR-SL-S-400-I-LP-current transmitter 2813509,MCR current measurement transmitter, used to measure sinusoidal and non-sinusoidal AC current, input current 0...400A, loop power supply, output 4...20mA

Product Type Current transmitter
insulation characteristics
Overvoltage Category III
pollution level 2

rated conditions 1W
test voltage, input/output 4.13 kV AC (50 Hz, 60 s)
step response (10-90%) < 340 ms
maximum temperature coefficient < 0.025 %/K
Maximum transmission error <1% (of terminal value)
Rated insulation voltage 300V AC (ground)
power supply
Supply Voltage Range loop power supply, no external power supply required

signal
configurable/programmable is
current input signal 0 A ... 400 A
measurement
Input current range 0 A AC ... 200 A AC
0 A AC ... 300 A AC
0 A AC ... 400 A AC
the setting range of the minimum input current 0 A AC ... 200 A AC
maximum input current 0 A AC ... 400 A AC
Overload depends on bottom wire
surge strength depends on the wire connected by the perforation.
Frequency measurement range 30Hz ... 6000Hz
Curve Type sinusoidal and non-sinusoidal
Operating Threshold 1% (of terminal value)

signals: current
current output signal 4 mA ... 20 mA
Maximum current output signal < 25 mA
load/output load current output (UB- 12 V) x 350 / 12 A

Connection Mode screw connection
stripping length 8mm
thread M3
Rigid conductor cross section 0.2 mm² ... 2.5 mm²
Flexible Wire Cross Section 0.2 mm² ... 2.5 mm²
Attachable Guide Cross Section AWG 24 ... 14
Tightening torque 0.5 Nm ... 0.6 Nm (4,4 ... 5,31 lbf-in.)
Connection Mode perforated connection

Product Size
width 55mm
height 85mm
depth 70.5mm
Round wire
diameter ≤ 18.5mm

color Green (RAL 6021)
Shell Material Non-reinforced polyamide PA

environmental conditions
protection level IP20
Ambient temperature (operation) -20°C ... 60°C
ambient temperature (storage/transport) -40°C ... 85°C
2813486

Phoenix MCR-SL-S-400-I-LP-current transmitter 2813509

Product Center

PRODUCT CENTER