Phoenix MCR-SL-S-400-U-current transmitter 2813473,MCR current measurement transmitter, used to measure sinusoidal and non-sinusoidal AC currents, input current 0...400A, output voltage 0 ..(5)10V
Product Type | Current transmitter |
insulation characteristics | |
Overvoltage Category | III |
pollution level | 2 |
rated conditions | 1W |
test voltage, input/output | 4.13 kV AC (50 Hz, 60 s) |
step response (10-90%) | < 340 ms |
maximum temperature coefficient | < 0.035 %/K |
Maximum transmission error | <1% (of terminal value) |
Rated insulation voltage | 300V AC (ground) |
Power | |
Rated supply voltage | 24V DC |
Supply Voltage Range | 20V DC ... 30V DC |
Maximum current consumption | < 30 mA |
signal | |
configurable/programmable | is |
current input signal | 0 A ... 400 A |
measurement | |
Input current range | 0 A AC ... 200 A AC |
0 A AC ... 300 A AC | |
0 A AC ... 400 A AC | |
minimum input current | 0 A AC ... 200 A AC |
maximum input current | 0 A AC ... 400 A AC |
Overload | depends on bottom wire |
surge strength | depends on the wire connected by the perforation. |
Frequency measurement range | 30Hz ... 6000Hz |
Curve Type | sinusoidal and non-sinusoidal |
Operating Threshold | 1% (of terminal value) |
signals: voltage | |
voltage output signal | 0V ... 5V |
0V ... 10V | |
Maximum voltage output signal | (0V ... 10 V) 14 V,(0 V ... 5 V) 7V |
load/output load voltage output | ≥ 10 kΩ |
Connection Mode | screw connection |
stripping length | 8mm |
thread | M3 |
Rigid conductor cross section | 0.2 mm² ... 2.5 mm² |
Flexible Wire Cross Section | 0.2 mm² ... 2.5 mm² |
Attachable Guide Cross Section AWG | 24 ... 14 |
Tightening torque | 0.5 Nm ... 0.6 Nm (4,4 ... 5,31 lbf-in.) |
Connection Mode | perforated connection |
Product Size | |
width | 55mm |
height | 85mm |
depth | 70.5mm |
Round wire | |
diameter | ≤ 18.5mm |
color | green (RAL 6021) |
Shell Material | Non-reinforced polyamide PA |
environmental conditions | |
protection level | IP20 |
ambient temperature (operation) | -20°C ... 60°C |